Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

CW2000 and RCP

I've installed my CiscoWorks2000 on Win2000 server recently.

I'm trying to configure my network devices to use RCP for config file transfer to my CW server.

Regarding to http://www.cisco.com/warp/public/477/RME/rcp.shtml I've configured

username cwuser password 7 .........

ip rcmd rcp-enable

ip rcmd remote-host cwuser x.x.x.x cwuser

ip rcmd remote-username cwuser

on my 3550 router.

I've also doublechecked all instructions regarding CW server configuration mentioned in http://www.cisco.com/warp/public/477/RME/rcp.shtml.

But turning debug RCMD on I'm receiving:

Dec 20 13:04:49.233: RCMD: [514 <- x.x.x.x:3352] recv \0

Dec 20 13:04:49.433: RCMD: [514 <- x.x.x.x:3352] recv cwuser\0cwuser\0rcp -f running-config\0

Dec 20 13:04:49.433: RCMD: [514 -> x.x.x.x:3352] send <OK>

Dec 20 13:04:49.433: RCMD: [514 <- x.x.x.x:3352] recv <OK>

Dec 20 13:04:49.433: RCMD: [514 -> x.x.x.x:3352] send <BAD,Permission denied.>\n

My feeling is that there is necessary to configure cwuser password somewhere in CW server configuration - I've set the password on the router so it should be set the same value on the server, shouldn't it?

But I've not found any cwuser password dialogue box.

Another question:

How to configure the same feature on CatOS devices where no user passwords are used?

Thanks,

Milan

2 REPLIES
Anonymous
N/A

Re: CW2000 and RCP

For informtaion regarding configuration of network devices, you can use the follwoing URL:

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/camp_mgr/cwsi_2x/cwsi_2_3/mgr_sol/solinstl.htm

Re: CW2000 and RCP

Thanks,

but the link you provided is about Solaris, I'm running my CW2000 on Windows 2000.

Regards,

Milan

122
Views
0
Helpful
2
Replies
CreatePlease to create content