I have installed CiscoWorks 5th Edition on a UNIX system with dual CPU and I did not get any errors but there are several functions that I cant run. I think that I somewhere for long time ago saw a guideline how to do such a installation on a dual CPU system but I cant remember where.
I would be very pleased if any one please could help me.
I have CW2000 on dual CPU and quad CPU Sun machines, I didn't follow any special procedures, except that on the 420R there was a problem with a script that was looking for processor 0 and a dual processor 420R doesn't have a processor 0 (it has a processer 1 & 2). But this was a rather obvious problem causing the install to die without completeing - although if I recall correctly it didn't give an error message, it just died. Check psrinfo and if it doesn't list a processor 0 that might be the problem.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...