Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CW2000 Path Analysis ?

I am running ver. 3.2 of path analysis – notices odd behavior – when I do trace from a Unix box to Unix box that are on the same VLAN – layer 3 info looks ok. When I do a trace form Windows server to Windows server that are on the same VLAN the layer 3 trace always shows the trace going through a router ? When I do the trace route from command prompt of the windows server it seems ok ( no hops).

Any ideas on this ?

1 REPLY
Silver

Re: CW2000 Path Analysis ?

On top of my mind, I have this: Is there an alternate route or does the windows server have two interface cards? Because, as per Cisco documentation, Layer 3 tracing does not support PCs or workstations with more than one network adapter.

Any other reasons anyone could think of.

75
Views
0
Helpful
1
Replies
CreatePlease to create content