Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CW2k Integration adapter doesn't work any new versions out there ?

Hi All,

I have been trying to install the CW2K integration adapter on a Solaris 2.7 machine with NNM, and the installation fails when JRE 1.1.6 is installed, has anyone had the same problems, any way around it ?




Re: CW2k Integration adapter doesn't work any new versions out t

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center ( or speak with a TAC engineer. You can open a TAC case online at

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: CW2k Integration adapter doesn't work any new versions out t


Unfortunately I rarely inhabit the Solaris world, but have seen problems on Windows platforms.

My symptoms are no symbol updates, although MIB's appear to load OK, and the script appears to run OK.

Initially the adapter script was looking under Windows for a very specific default installation path, eg. C:\Program Files\CSCOpx.... and I had the install root under another drive.

The log file I think was the standard CSCOpx install log (it's at the root of the system partition in Windows - not sure if it lives in /opt or maybe /opt/CSCOpx in Sol.) Those log entries were useful when I chose to install NNM integration when installing CDOne but I can't seem to find the log file when doing the integration at a later stage.