CW2K: no telnet, only SSH, and no read-only SNMP on routers/switches
I am in a locked-down environment. Telnet was disabled to all devices, SSH was enabled (transport input ssh).
The SNMP RW string is not present, only read-only.
Will I still be able to use CiscoWorks 2000, specifically Resource Manager Essestials to do software images, etc. What is broken without telnet? Will CW2K do SSH? Is there a roadmap for SSH, SNMPv3, etc for.
I add new devices to RME, and get "could not connect to host", I assume the new device is attempting a telnet, which of course won't work. Any workarounds?
Re: CW2K: no telnet, only SSH, and no read-only SNMP on routers/
I have a similar situation and am running RME3.5, SSH works fine for configuration managment but for SWIM it always fails. SSH is configured as the primary transport but this seems only applicable to Configuration Managment and not Software Distribution. The error message comes back something like 'telnet failed'. The majority of kit is Catalyst 3550's running the Layer-2 Crypto image, the VTY lines are configured to only allow SSH (transport input ssh).
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.