When I use the compare config feature of RME on some devices, the output doesn't line up. I get all of the output from one device- marked as "unmatched", then get all the output for the other device, also marked as "unmatched". My first thought was different IOS versions, but that isn't it. Any ideas?
What is the exact message that is being thrown up on the RME ? I guess, you are using the COnfiguration Manager for compare configs. If so, please check the following documentation might help you in understanding the issue.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...