Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cw2k RME3.4 can not authenticate to telnet devices

Hi, I want to change a config and download it into a ios-device. (using RME3.4 config editor)

When I start the download it failed "invalid TACACS user name and password"

cw2k login via ACS3.1 is the same user login as used for the ios devices.

thx

Kris

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: cw2k RME3.4 can not authenticate to telnet devices

Kris,

You first need to make sure that device credentials are correct under "check device attribute" If using TACACS, it should follow with the TACACS enable or you can try using TACACS credentials as local user.

3 REPLIES
Blue

Re: cw2k RME3.4 can not authenticate to telnet devices

Are the device credentials correct for this device in RME?. If not, then use Change Device Attributes to update them and can use Check Device Attributes to verify.

New Member

Re: cw2k RME3.4 can not authenticate to telnet devices

Kris,

You first need to make sure that device credentials are correct under "check device attribute" If using TACACS, it should follow with the TACACS enable or you can try using TACACS credentials as local user.

New Member

Re: cw2k RME3.4 can not authenticate to telnet devices

Thx problem solved

396
Views
0
Helpful
3
Replies
CreatePlease to create content