Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CW2K user roles & CiscoView

I would like to tune user access to switches via CiscoView. But as far as I know CW2K user roles actually only apply to RME. SNMP communities in CiscoView on the other hand are applied gobally. So how could I configure CiscoView that some user can set SNMP variables on switches and others cannot ?

Thanx

3 REPLIES
New Member

Re: CW2K user roles & CiscoView

try to define an ACL which permits specific hosts such as

ACCESS-LIST 1 PERMIT 10.10.10.10

and add this list to the end of SNMP community statement

SNMP-SERVER COMMUNITY READSNMP RO 1

SNMP-SERVER COMMUNITY WRITESNMP RW 1

New Member

Re: CW2K user roles & CiscoView

Thanx

But how should that work? All SNMP request come from the CW2K server, no matter which user is using CiscoView. The user's request is send to the CW2K server via http or Java, and then the SNMP request is send to the switch.

New Member

Re: CW2K user roles & CiscoView

User accounts set to the help desk priviliges do not have the ability to send an SNMP set command. The write SNMP community string line is grayed out when they go to a device so even if they know the write community string, it will do them no good. The other main user roles can send set requests.

-Dave

94
Views
0
Helpful
3
Replies