Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CWSI 2.4 - 2948G shows red on map and un-pingable

I am sure that this is a simple problem. I have a Cisco 2948G that showed up with a red x through it. It's been previously on my map,but now I can't Cisco View it or telnet to it. It is linked via a T-1 line, a 1601R (which is on the network)into a AS5300.

I will be going over later today to console into it locally. The users are still getting their DHCP addresses and connect to the rest of our network.

Any ideas?

TIA,

Mitch

1 REPLY
New Member

Re: CWSI 2.4 - 2948G shows red on map and un-pingable

The funny thing is, I went over there and plugged into the console and everything is working. Any ideas?

Thanks,

Mitch

105
Views
0
Helpful
1
Replies
CreatePlease login to create content