Q1. Installed CNR with DDNS configured. Can't ping FQDN for dynamic hosts. Read document & realised need to specify "to receive DHCP update from these addresses" field. Did that by also included 127.0.0.1 as the DNS & DHCP are the same box. Still can't see registered dynamic hosts in DNS database?
Q2. Configured DHCP fail-over with both primary & backup on two different CNR servers. When right click on DHCP for related servers, found that in primary DHCP with error message of "Communication: Interrupted" & "Status: Partner Down"? In Backup DHCP, the message is just "Status:Recover" ?
Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...