We want to backup a serial line, connected to a 7200, which, by itself, is connected to a radius-server. Via Ethernet, we have an as5300 connected to the 7200, where the ISDN backup should terminate. The problem is, that if the 7200 goes down, the effect is that
<p>a) backup ddr is triggered
<p>b) no connectivity to radius is available.
<p>So the CPE dials, and dials, and dials (about 15 times a minute, with no success of course).
any idea for this scenario? how can i configure a backoff, which dials for example 3 times, waits for 2 minutes, dials 3 times, waits for 4 minutes ... and so on?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.