DDR encapsulation failed at called end trying to respond
I have a dial up link between two routers using the serial ports and synchronus modems. I set up a simple dial link like this on both ends except for the ip and phone #s. Encapsulation is hdlc and no authentication.
ip address 10.0.0.2 255.255.255.0
dialer enable-timeout 2
dialer wait-for-carrier-time 40
dialer map ip 10.0.0.1 1
dialer hold-queue 20
dialer-list 1 protocol ip permit
I can get it to dial and connect both directions. Sending host gets encap errors until line comes up, thats normal. Problem is the responding host says no dialer available and gets encapsulation errors trying to answer. It doesn't seem to know the link is up even though it just received data on it.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...