Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DDR for 100+ remote servers

I have a 3620 router and tomorrow I will recieve a WIC-2am (2 port modem card) I am trying to write up a plan of action for setting up the router to dial a number that is associated with an IP address.

Ex. When a workstation on the LAN requests a webpage on 10.100.100.5 the router will dial the phone number associated with 10.100.100.5.

I will have over a hundred phone numbers/remote servers that will need to be configured.

FYI:

The remote servers only use PAP

Remote servers are connected via wireless modem

I have minimal experience with Remote Access Networks, if anybody can offer up some advice to help get me started, it would be greatly appreciated.

Thanks in advance

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: DDR for 100+ remote servers

You need to configure a router for a "Large Scale Dialout" ..Here is the url for more info on that

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120t/120t3/lsdial.htm

1 REPLY
Cisco Employee

Re: DDR for 100+ remote servers

You need to configure a router for a "Large Scale Dialout" ..Here is the url for more info on that

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120t/120t3/lsdial.htm

187
Views
0
Helpful
1
Replies
CreatePlease login to create content