DDR for 100+ remote servers

[brookstone]

I have a 3620 router and tomorrow I will recieve a WIC-2am (2 port modem card) I am trying to write up a plan of action for setting up the router to dial a number that is associated with an IP address.

Ex. When a workstation on the LAN requests a webpage on 10.100.100.5 the router will dial the phone number associated with 10.100.100.5.

I will have over a hundred phone numbers/remote servers that will need to be configured.

FYI:

The remote servers only use PAP

Remote servers are connected via wireless modem

I have minimal experience with Remote Access Networks, if anybody can offer up some advice to help get me started, it would be greatly appreciated.

Thanks in advance

[tepatel · Accepted solution]

You need to configure a router for a "Large Scale Dialout" ..Here is the url for more info on that

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120t/120t3/lsdial.htm