I am trying to configure dialer profiles to allow incoming calls to use unique local CHAP names per profile. The problem is that the Cisco router sends the hostname as the local CHAP when the call first connects, this causes the remote site to fail because it does not have the hostname configured in its user database. If I configure caller-id then the Cisco correctly identifies the appropriate profile and uses the local CHAP name configured in that profile.
The current central router waits for the remote site to send its CHAP challenge first then correctly identifies which local chap name to use.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...