06-26-2002 02:16 PM - edited 03-01-2019 10:53 PM
I am seeing increased traffic on an Ethernet interface and want to know which ports are being used.
Can I set up an access list and then debug it for successful hits?
I've created a permit ip any any log and the hits I see have no port numbers, just (0) after the source and destination IP's
06-26-2002 02:16 PM
Do you have fast-switching enabled?
A debug command will be bypassed
for fast-switched traffic. You
would have to process switch your
traffic in order to be able to
see the traffic in a debug.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community