Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

debug access lists

I am seeing increased traffic on an Ethernet interface and want to know which ports are being used.

Can I set up an access list and then debug it for successful hits?

I've created a permit ip any any log and the hits I see have no port numbers, just (0) after the source and destination IP's

  • Other Network Infrastructure Subjects
1 REPLY
Anonymous
N/A

Re: debug access lists

Do you have fast-switching enabled?

A debug command will be bypassed

for fast-switched traffic. You

would have to process switch your

traffic in order to be able to

see the traffic in a debug.

147
Views
0
Helpful
1
Replies
This widget could not be displayed.