Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

debug cas:

Hello,

I configured my AS5800's E1 controller for CAS signalling with type r2-digital & r2-compelled. Why my IOS does not support "debug cas" command to track the CAS events.

The IOS version is "c5800-k8p4-mz.122-13.bin"

Any other debug command do the identical function of "debug cas".

The config goes here

controller E1 1/0/0

framing NO-CRC4

ds0-group 0 timeslots 1-15,17-31 type r2-digital r2-compelled ani

cas-custom 0

invert-abcd 0 0 0 1

country india

release-guard-time 20

caller-digits 6

dnis-digits min 1 max 6

ani-digits min 1 max 11

All inputs welcome.

Thanks

Is there any other

1 REPLY
Bronze

Re: debug cas:

For "debug cas", you ll need to get into the linecard....so do a "dsip console slave " for your T1 card in slot n , and then run "debug trunk cas".

~Zulfi

377
Views
0
Helpful
1
Replies