Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Debug commands do not display the time

Hi,

I use the debug commands -debug isdn events, debug ppp auth, and debug dialer. While the debug info is displayed on the screen, there is no evidence of the time when each debug activity has taken place. Appreciate info on a command that will display the clock time with each debug activity displayed. We use a 1600 series router.

Thanks in advance.

1 REPLY
New Member

Re: Debug commands do not display the time

use the following command

R4(config)#service timestamps debug datetime msec

This assuming you have already setup the correct time would give you the correct info.

205
Views
0
Helpful
1
Replies