Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

debug dialer packets

I have 2 E1 interfaces on a CIsco3640 they are both connected to ISDN30e lines. I have 2 serial interfaces set up as:

s0/0:15

no ip address

encapsulation ppp

dialer rotary-group 1

isdn switch-type primary net5

ppp authentication chap

s1/0:15

no ip address

encapsulation ppp

dialer rotary-group 2

isdn switch-type primary net5

ppp authentication chap

These two interfaces point towards two dialer interfaces called dialer 1 and dialer 2.

My problem is that even though dialer 1 with its dialer maps works ok. The dialer maps on dialer 2 don't. When I use the debug dialer packets command I get the following output

17:58:00: Di2 DDR: ip (s=10.40.0.154, d=192.100.1.34), 60 bytes, outgoing uninte

resting (dialer-list 2 not defined)

If debug dialer events I get nothing. Can someone please enlighten me as to what the above output is telling me ????

1 REPLY
Silver

Re: debug dialer packets

I am note sure without seeing your whole config but it looks from this that the dialer 2 has dialer-group 2 configured and you have no dialer-list 2 configured on this box , if you add 'dialer-list 2 protocol ip permit ACL#' the dialer should work .

186
Views
0
Helpful
1
Replies
CreatePlease to create content