I have 2 E1 interfaces on a CIsco3640 they are both connected to ISDN30e lines. I have 2 serial interfaces set up as:
s0/0:15
no ip address
encapsulation ppp
dialer rotary-group 1
isdn switch-type primary net5
ppp authentication chap
s1/0:15
no ip address
encapsulation ppp
dialer rotary-group 2
isdn switch-type primary net5
ppp authentication chap
These two interfaces point towards two dialer interfaces called dialer 1 and dialer 2.
My problem is that even though dialer 1 with its dialer maps works ok. The dialer maps on dialer 2 don't. When I use the debug dialer packets command I get the following output
17:58:00: Di2 DDR: ip (s=10.40.0.154, d=192.100.1.34), 60 bytes, outgoing uninte
resting (dialer-list 2 not defined)
If debug dialer events I get nothing. Can someone please enlighten me as to what the above output is telling me ????