Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Debug priority

Hi,

I have cisco router 1720 connected back to back with a cisco router 2610 through ppp.

I configured priority queueing on these routers in order to alocate traffic coming from one specific ip to another, to the high queue.

When I issued the debug priority command and generated the desired high priority traffic, I didn't get from the debug command anything stating that high traffic is being queued. I also generated low priority traffic but still nothing in the output of the debug concerning that low traffic.

what can be the problem?

1 REPLY
Bronze

Re: Debug priority

Priority queuing only kicks in once there is contention on the interface; at that point the high priority traffic will get preference, and you should then see some debug. So make sure that you have enough data to introduce contention.

117
Views
0
Helpful
1
Replies
CreatePlease to create content