Hi, I have 4 vlans (1-4), Nr. 1 is the managements vlan. The trafic is going through all 4 vlans. When i start "debug ip packet" i only see the packets going through VLAN1. Why i don't see the packets going through VLAN3-4? How to debug all 4 vlans? Thank you! Vlado
2950 is not a router and all packets are switched in hardware except for cpu bound traffic. Vlan is for management only. the debug will not capture non-management user traffic being switched in hardware. Using debug ip packet to analyse packets is not a good idea. use other ways like sniffer or other means.
Thank you very much for THAT quick response, but i think you misunderstood me. I'm talking of course about a switch C2950. After starting "debug ip packet" i see all the IP's which are communicating in VLAN1. That's fine, i don't need to see anything else. But i also want to see the IP's in VLAN2, 3 and 4.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...