Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Debugging VTP messages

Does anyone know what command/s can I use to see/debug VTP messages? This question is applicable to all Cisco platforms including routers, native IOS switches and CatIOS switches. Thanks in advance for your answer.

2 REPLIES
Bronze

Re: Debugging VTP messages

There's a command "debug sw-vlan vtp" on Catalyst

2950, 4000, and 6000 running IOS. The command can

also be used on Cisco 7600 Internet routers.

For CatOS, the tools you might use are show vtp,

show vlan, and show trunk commands.

The following link might help:

http://www.cisco.com/en/US/tech/tk389/tk689/technologies_tech_note09186a0080094c52.shtml#vtp_ts_cav

For other routers used for inter-VLAN routing,

the command "debug vlan packet" can be used to

check for packets that the router has received

but is having some problems handling.

Hope this info helps.

Cisco Employee

Re: Debugging VTP messages

debug sw-vlan vtp will also work on the 3550 and cat2900XL/3500XL.

You cannot debug VTP on routers.

1533
Views
0
Helpful
2
Replies
CreatePlease login to create content