I have two 1750 router with wic-2T card. and i have 4 X 64Kbps leased line.I have connect 2X64 Kbps on one router and 2 X64 on the other router.The other end of all the Leased line are connected to a 3662 router at the other end (i.e they all have a common destination).i want to use all the 4 links. I have a problem such that how do i specify the gateway on the nodes, since 2 routers will have different ethernet ip address.
HSRP Groups. One Group is on one router aktive and
the other group on the second router. Now that allone does not help, you also have to devide the clients gateways and asingn one groube HSRP 1 adrees as the gateway and the other group HSRP 2 address.
Depends on the routing protocol but you also could create an link to balance the load between the routers. Then you just have to see that the 4 different way to the destination have the same metric/cost.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...