In my network I have various vlans configured. Inter-vlan routing is done by a 2948g-l3. The switch is connected to a router which in turn is connected to the wan. Is it correct to create 2 default routes in my router or should I create a default route to the wan and static routes to my vlans?
you need to define default route on the 2948 to point toward your router ( assuming this is only way out for the vlans to get to anywhere ) and on the router and wan router, puts static routes for the vlans on the 2948g...
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...