Have 2 routers running eBGP and using static routing internally. Instead of using default route of - ip route 0.0.0.0 0.0.0.0 hssi 2/0 - I want to static route each subnet out hssi 2/0 i.e. - ip route 188.8.131.52/24 hssi 2/0-
- ip route 184.108.40.206/24 hssi 2/0-
and then set my default route to go to my other backbone router i.e.
- ip route 0.0.0.0 0.0.0.0 220.127.116.11 -
If the line protocol on HSSI 2/0 happens to go down, will the traffic take the default route or will the router keep trying to pump the traffic out an up/down interface??? Does this seem like a good failover scenario for static routing??
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...