Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Delete all e1 lines under an e3 controller

Hi,

Any pointers to delete all the e1 lines configured under an e3 controller with one command?

regards,

Sathya

1 REPLY

Re: Delete all e1 lines under an e3 controller

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

123
Views
0
Helpful
1
Replies
CreatePlease to create content