Delete built-in VLAN1 and/or upgrade to Adv IP IOS on Cisco 878
Hi all. I'm a Cisco newbie and need some help with 878 router. Managed to set the config to work with the SDSL line, using the built-in VLAN1 (all four ports in it). But I need only one eth port going to a switch on the private LAN. I also need another eth port for additional public IP for one server. I can't add another VLAN, doesn't let me.
On another forum someone mentioned that you can only add VLAN on Adv IP IOS, not on Security IOS. Is that my problem? Alternatively, will deleting the VLAN1 and entering same settings on Fa0 work ok? Whta's best for me to do?
Any way to get this Adv IP IOS? I was expecting the router to have built-in VLAN feature, not needing anything else.
Thanks a lot in advance. I really need to get this going and I'm stuck googling for days. :( Cheers. Darko.
Re: Delete built-in VLAN1 and/or upgrade to Adv IP IOS on Cisco
Thanks for the reply.
What about the "free" option, deleting the VLAN1 and configure Fa0 with the same settings as VLAN1 is now, then configuring Fa1 for example with the additional public IP as gateway for the server with public IP? Will this 878 work properly at all if I delete VLAN1 because it was built-in?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...