Deliver config via console

[m1c]

I haev a 2620 router I need to send a new config to. When I use hypertrm via the Console port & attempt a copy xmodem startup-config, I get the error: Error opening xmodem: (Read-only file system)

How can I deliver this config via the console port?

[vmiller]

since you are directly connected, whay not just send text file once you are in configuration mode ?

[m1c]

What procedures are you thinking would get me through this?

[edangel]

from the console port login using hyperterminal or any other comms s/w. if required (good security) enter password type "enable" may ask for another password (good security). Then type "configure terminal" should get the hostname(config)# prompt. simple copy paste config file from this point. type "end" then "copy run start" if router is performing as desired. if not type "reload". sorry if too basic I may have missed point.