Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Description

I am trying to run command show interface description on Cisco 2950 Switch .

Th output of command appears in one or two lines showing only the description entered for few ethernet ports. It does not show any port with status UP or down..

what could be the problem ?

regds,

aman

9 REPLIES

Re: Description

Can you just post the output?

New Member

Re: Description

Sir,

Please find the show version & output of sh int des command

regds,

aman

Re: Description

hi

Can you try with show interface status which will give u the port type,status,duplex also the vlan membership details..

regds

New Member

Re: Description

Sir,

I have tried with show interface status and i am able to get the o/p as mentioned by you.

Is this something to do with IOS of switch ?

Any way thanks a lot

Re: Description

I think you can upgrade the IOS on the switch, looking at the version of the IOS, i think its an old IOS image. so try that, hope it will work.

Purple

Re: Description

From your post and the attached memo , it appears that you have pretty old code and that may be whats causing it , this is a fairly new command that may not be on that old of code , try upgradeing the code . Works fine on all our 2950's .

New Member

Re: Description

Sir,

I have one more query . Recently, we have purchased Cisco 7206VXR router . In this router , when we run show interface description , message comes

% Invalid input detected at '^' marker.

version of router is

c7200-ds-mz.122-11.T10.bin

Is there any alternate command with which I can find out what all links are UP since on the same router we have got two channelised E1, PRI & 2Mbps links.

regds,

aman

Re: Description

Try,

" Show ip int brief "

regards,

-amit singh

New Member

Re: Description

This command is working but this does not show me, which particular location /site is terminating at which serial port of router .

regds,

aman

195
Views
0
Helpful
9
Replies
CreatePlease login to create content