Does the 4006 Catalyst Switch have any serial line modules to connect WAN connections. I was wondering if it's possible to get rid of our existing 3620 routers if we installed a 4006 for LAN and WAN connectivity? Also, if it is possible to connect serial links to the 4006 is there any data compression solutions?
The Sup2 4006 does support the AGM module which has serial line capabilities. Currently, the AGM modules is not supported with the Sup3. The AGM may not be a cost effective solution as it is designed for Voice Applications as well.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...