You need to create separate IP subnets which you can route traffic onto from the PIX.
I don't know much about the PIX but you may be able to create subinterfaces on the PIX and use 802.1q or ISL trunking to the 6513. Then use port based VLAN's to put the customers machines into the correct networks.
QOS would depend on where you were implementing it.
Personally I would have the PIX just handling the security and then have a RSM in the 6513 with layer 3 switching turned off (so the RSM handles all routing and you can use ACL's to block traffic going between customers VLAN's)
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.