Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Destination port translation

We have a server located on the web which host a application on port 8888.

The clients are on VSAT with private IP ( 10.x.x.x ) and get NATed to 203.x.x.x at the HUB before accessing the server 194.x.x.x.

Problem: Due to some reasons in the VSAT we are not able to forward the port 8888. We can configure the client to access at port 21 instead of 8888. Now the NAT router at the HUB needs to translate this port 21 to 8888 on the destination address 194.x.x.x.

We have tried all the possible combinations with "Ip nat inside/outside.." and "IP nat service..", but all of them seems to work only on source ports and not on destination port. We are using cisco 7206 for NAT with IOS 12.0(7)XE1.

1 REPLY

Re: Destination port translation

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

102
Views
0
Helpful
1
Replies
CreatePlease to create content