Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Detecting Catalyst ports in an err-disabled state using SNMP

I have some Cat3550's and some 4500's that I'd like to poll using NET-SNMP to look for ports in an err-disabled state. Did an snmpwalk of a switch that has a port in that state and didn't see anything that indicated the port was err-disabled. Is it possible to use SNMP to check for this, and if so, and suggestions on which MIB to use.

1 REPLY
Blue

Re: Detecting Catalyst ports in an err-disabled state using SNMP

There is a c2900PortStatus in CISCO-C2900-MIB. Not sure if this MIB is supported on your deviecs or not.

121
Views
0
Helpful
1
Replies