04-22-2003 08:55 AM - edited 03-02-2019 06:48 AM
I am trying to document the routers at all of my remote locations. I was hoping to be able to gather the serial number of the routers remotely through the CLI so that I can determine if they are under currently supported under a Cisco service contract or not. Is there a command that I can use to do this? I thought that the 'show diag' would display it, but the serial numbers there do not match the ones on the back of the router from what I can tell.
Thanks,
Justin Loucks
04-22-2003 09:09 AM
For routers, you first need to add the chassis serial number manually in the router config via CLI using the command "snmp-server chassis-id
Router#sh snmp
Chassis: 1234567890 <----!!!
Contact: Foo
373698 SNMP packets input
0 Bad SNMP version errors
04-22-2003 10:06 PM
Pls also note that the serial number output in the show version is that of the mainboard.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: