Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Device Availability stats in RME 3.3

When using the device availability stats in RME 3.3 it is reporting 80% availability on certain devices almost continually (particularly with the Cat6500s). When checking the availability of these devices with continuous pings there are no packets lost and there are no availability problems. Polling options have been amended with no change in the reported 80% availability and as this is based on ICMP and SNMP responses I can't think of any reason why this is being reported. Any suggestions anyone?

1 REPLY

Re: Device Availability stats in RME 3.3

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

116
Views
0
Helpful
1
Replies
CreatePlease to create content