09-19-2006 05:09 PM - edited 03-03-2019 05:07 AM
I have a 6500 with a CFC daughter board on a 10GE line card, but the sh hard says its a DFC.
Has anyone seen this before?
C3DIM_CO_M2_C1#sh mod
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 2 Supervisor Engine 720 (Active) WS-SUP720-3B SAL1025SFHP
2 48 CEF720 48 port 1000mb SFP WS-X6748-SFP SAL1025SH5K
3 4 CEF720 4 port 10-Gigabit Ethernet WS-X6704-10GE SAL1007DPUV
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
1 0013.c43b.2178 to 0013.c43b.217b 5.2 8.4(2) 12.2(18)SXF5 Ok
2 0018.7369.faf0 to 0018.7369.fb1f 1.7 12.2(14r)S5 12.2(18)SXF5 Ok
3 0016.c7ff.64a0 to 0016.c7ff.64a3 2.2 12.2(14r)S5 12.2(18)SXF5 Ok
Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
1 Policy Feature Card 3 WS-F6K-PFC3B SAL1025SGVY 2.3 Ok
1 MSFC3 Daughterboard WS-SUP720 SAL1025SGJK 2.5 Ok
2 Distributed Forwarding Card WS-F6700-DFC3A SAL1019MRQY 2.5 Ok
3 Centralized Forwarding Card WS-F6700-CFC SAL1013H3X8 2.0 Ok
Mod Online Diag Status
---- -------------------
1 Pass
2 Pass
3 Pass
C3DIM_CO_M2_C1#
09-19-2006 07:39 PM
David,
Based upon the "Show Mod" output,Your Hardware Configuration looks like:
First Slot - SUP720 with PFC3B & MSFC3
Second Slot - WS-X6748-SFP with DFC3A
Third Slot - WS-X6704-10GE with CFC
Based on this, you have a Distributed Forwarding Card (DFC) for the 6748 module and Centralized Forwarding Card (CFC) for the 6704 module.
I hope it helps.
Regards,
Arul
09-20-2006 03:41 AM
The only difference is that they add an extra board that will hold on board routing tables and the routing decisions are made at the card level instead of the cpu .
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide