Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

DFM 1.1 NT Unregister and Reregister Adapter Deamons

Why DfmServer do not start after unregister and reregister process? Always it starts and then stops.

C:\>pdcmd -s DfmServer

Process= DfmServer

State = Administrator has shut down this server

Pid = 0

RC = 1

Signo = 0

Start = 01/11/02 01:46:09 PM

Stop = 01/11/02 01:46:09 PM

Core = Not applicable

Info = Server started by admin request

Thanks.

1 REPLY

Re: DFM 1.1 NT Unregister and Reregister Adapter Deamons

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

111
Views
0
Helpful
1
Replies
CreatePlease to create content