Sorry about this , but you are correct , my question was regarding DFM 1.2 and the cat 4006 SUP III - I downloaded the latest packages , but it will not work - native IOS on the cat 4006 - I also have the same problem with the cat 6513 with native IOS with L3 links to the cat 4006 - does DFM also not support cat 6513 with native IOS
I can see the 6513 , but no logs are seen , if I drop one of the L3 links to the other switches (even to another 6513 ) , DFM does not report any errors - I should see a log for Gi1/1 is down and a mail should be sent to the recepient.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...