What does DFM do when it receives trap messages for unsupported TRAP MIBS or from unmanaged devices? Is there a file in which the OIDs for an unsupported trap can be viewed? I'm thinking along the lines of HPOV where, even if a trap is not shown in the alarm browser, its still possible to view any traps that have been received via the trap receiver by looking at xnmevents.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...