Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DFM Alarm

any system error recognized C6500 but DFM alerm is come up all the time.

description:HighQueueDropRate,HighUtilization,High Broadcast Rate etc...

How do I check these.

1 REPLY
Silver

Re: DFM Alarm

Hello Miyakawa,

I am not sure if this is your exact requirement, but you can customize the view using filters. Filters are used to control information in the Alarm Log view so you can immediately recognize the important messages. Only incoming notifications that match your filter criteria are displayed

Go here for additional information and for steps to Customize the Alarm Log View with Filters:

http://www.cisco.com/en/US/customer/products/sw/cscowork/ps2421/products_user_guide_chapter09186a008008053e.html#80668

Hope that helps,

102
Views
0
Helpful
1
Replies
CreatePlease to create content