If DFM is not listing/showing the 3rd power supply there, it cannot do any fault management for that particular element either. Try deleting this particulat switch from the DFM Administration Console and then re-add it back again manually using Add Agent option and see if it shows the 3rd power supply or not. As a side note, if you have not installed DFM 1.1 IDS 1.1.2 patch from CCO, you may want to install that as well.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...