Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

DFM and Catalyst Switch Setup

I am configuring DFM 1.1 on my network and want am a little unclear on my switch setup. Currently I have snmp enabled and snmp traps sent to DFM on por 162 and DFM listening on port 162. I do not have any snmp traps types set however and am not sure if I need them, or which ones I need. Can someone shed some light on this. I have tried the documentations but seem to refered to the same docs. I have Catalyst 4006 and 6509's if it matters.

Ray

1 REPLY
Blue

Re: DFM and Catalyst Switch Setup

Docs have this info in detail. FAQs are also very useful:

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/dfm/dfm_faq.htm

Once you enable SNMP on the device and add it in the DFM inventory, you can setup the polling details/threshold for the faults that you want DFM to monitor for.

84
Views
0
Helpful
1
Replies
CreatePlease to create content