Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

DFM polling and thresholds

In the thresholds console I do not see my access ports and therefore cannot implement port flapping or utilization thresholds. Also if I enable anything in "matching criteria" in either polling or thresholds, I lose all of my members of that group. that doesn't seem right. If that was right then how could you group say all 3550 switches?

1 REPLY
Blue

Re: DFM polling and thresholds

By default, DFM manages trunk ports but does not manage access ports, if that's what your question implies.

194
Views
0
Helpful
1
Replies
CreatePlease to create content