I'm working on the same issue here and when I try to use the ip forward-protocol or ip helper-address i always get "invalid input at ^ marker" where the ^ is pointing to "forward."
I've been reading about these 2 commands from the link above and also from the 2950 and 3560 user manuals, but the commands don't seem to work. Routing is configured on the 3560 vlan communication between the VLANs works properly. Any ideas?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...