I am currently trying to configure manual bindings on a router using DHCP. Configuring DHCP is relatively easy and painless, but how do you get the DHCP server on the router to statically assign an IP based on MAC address? I located some docs that mentioned using manual bindings, but the router appears to ignore the binding and assign any IP address in the Network pool. Can anyone tell me where I have gone wrong?
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...