DHCP for Dialup BRI users could not use the network resources
I have configured cisco 2621 router for one incomming bri session, such that user when dials get the ip addrss form Winnt DHCP server, But could not communicate form the network i-e nor ping the same network or communicate.
Even entring the static route. But gets ip address from dhcp server, but could not use the network.
Re: DHCP for Dialup BRI users could not use the network resource
We do need to see the debug for ppp negotiations for the call. So turn on debug for "debug ppp negotiation" and "debug ppp authentication". Capture it for a call which should get ip address from dhcp. Send that log along with running config. .Thanks..Tejal
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...