I have a DHCP pool setup to serve two FastEthernet interfaces, and I need to split it to two pools, one for each interface. Is it possible to do this, and if so, how do I do it?
Use the "ip dhcp pool" command was introduced on 12.0(1)T to set up the pool.
Here's the usage:
ip dhcp pool 1
network x.x.x.x 255.255.255.0
default-router x.x.x.x
However I am not too sure if it can be split into two for each interface.
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: