I need to connect to FastEthernet0/20 port one non-managable hub/switch so computers which will be connected to hub/switch (20-50 computers) may get IP address from ONLY that FastEthernet0/20 port DHCP service.
But for example, if I plug to FaEth0/15, I get no IP address, nothing.
And also I have 5 ports active on same switch FA0/1-0/5, and I don't want to disturb that servery anyhow.
I cannot put any PC for DHCP service for this solution.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...